• Lift up the fuel tank. ( 4-51)
• Disconnect the CKP sensor lead wire coupler and connect the
multi circuit tester with the peak volt adaptor.
Green (+ Probe) – Blue (- Probe)
• Measure the CKP sensor peak voltage at the CKP sensor lead
wire coupler.
V
V
V Tester knob indication: Voltage (
V
V
CKP sensor peak voltage:
If the peak voltage is lower than the standard range, check each
coupler at both ends of the circuit or replace the CKP sensor
and inspect it again.
CKP SENSOR RESISTANCE
• Measure the resistance between the lead wires and ground. If
the resistance is not specified value, the CKP sensor must be
replaced.
[
[
[
[
[ 09900-25008: Multi circuit tester set
U Tester knob indication: Resistance (Ω Ω Ω Ω Ω )
U
U
U
U
CKP sensor resistance : 70 – 220 Ω Ω Ω Ω Ω (Green – White)
)
More than 0.5 V (Green – Blue)
∞Ω (Green – Ground)
∞Ω
∞Ω
: ∞Ω
∞Ω
ELECTRICAL SYSTEM 7-27
CKP sensor
coupler
CKP sensor
CKP sensor
coupler
CKP sensor
Peak
volt
adaptor