Suzuki GSX-R750 Service Manual page 128

3-80 ENGINE
GENERATOR ROTOR
• Degrease the tapered portion of the generator rotor and also
the crankshaft. Use nonflammable cleaning solvent to wipe off
oily or greasy matter and make these surfaces completely dry.
• Install the generator rotor onto the crankshaft.
• Install the rotor bolt with the washer.
• Holding the generator rotor with the special tool and tighten its
bolt to the specified torque.
[ 09930-44530: Rotor holder
! Generator rotor bolt: 100 N . m (10.0 kgf . m, 72.3 lb-ft)
GENERATOR COVER
• Apply SUZUKI BOND "1207B" lightly to the mating surfaces at
the parting line between the upper and lower crankcases as
shown.
C 99104-31140: SUZUKI BOND "1207B"
• Install the dowel pins and new gasket 1.
#
Use the new gaskets to prevent oil leakage.
• Install the generator cover and tighten the generator cover bolts
to the specified torque.
! Generator cover bolt: 10 N . m (1.0 kgf . m, 7.0 lb-ft)
"
Be careful not to pinch the finger between the generator
cover and the crankcase.
NOTE:
Fit the gasket washer to the bolts A .