Suzuki GSX-R750 Service Manual page 276

FORK SPRING
• Install the fork spring as shown in the illustration.
FRONT FORK CAP BOLT
• Adjust the height A of the rebound damping force adjuster at
1.5 mm (0.06 in).
• Install the rebound damping force adjuster housing to the cap
bolt.
• Install the spring adjuster bolt and its stopper ring to the front
fork cap bolt.
#
The O-rings removed must be replaced with a new one.
• Install the washer 1, spacer seat 2, spacer 3 and oil flow
pipe 4.
NOTE:
Screw the damping force adjuster lock nut B fully on the inner
rod threads before installing the cap bolt.
• While holding the inner rod with the special tool C, compress
the spring with the special tool D and then insert the special
tool E between the lock nut and washer.
[ 09940-52841: Inner rod holder C
09940-94930: Front fork spacer holder D
09940-94921: Stopper plate E
• Install the rubber seat 5.
• Slowly turn the cap bolt by hand until the rebound damping
force adjuster seats on the inner-rod.
NOTE:
Be sure to adjust the height of the rebound damping force ad-
juster before installing the cap bolt.
• Hold the rebound damping force adjuster housing in a posi-
tion. Tighten the lock nut B to the specified torque.
! Damping force adjuster lock nut:
20 N . m (2.0 kgf . m, 14.5 lb-ft)
CHASSIS 6-25
Upper side
Lower side