C12" Ckp Sensor Circuit Malfunction - Suzuki GSX-R750 Service Manual

"C12" CKP SENSOR CIRCUIT MALFUNCTION

DETECTED CONDITION
No CKP sensor signal for 4 seconds at engine
cranking.
INSPECTION
• Lift and support the fuel tank with its prop stay. ( 4-51)
1 Turn the ignition switch OFF.
Check the CKP sensor coupler for loose or poor contacts.
If OK, then measure the CKP sensor resistance.
Disconnect the CKP sensor coupler and measure the re-
sistance.
CKP sensor resistance: 70 – 220 Ω Ω Ω Ω Ω
If OK, then check the continuity between each terminal
and ground.
CKP sensor continuity: ∞Ω
[ 09900-25008: Multi circuit tester
U Tester knob indication: Resistance (Ω Ω Ω Ω Ω )
Yes
2
Disconnect the CKP sensor coupler.
Crank the engine a few seconds with the starter motor, and
measure the CKP sensor peak voltage at the coupler.
CKP sensor peak voltage: More than 0.5 V
Repeat the above test procedure a few times and mea-
sure the highest peak voltage.
If OK, then measure the CKP sensor peak voltage at the
ECM terminals. (N+/N– or Z/c)
[ 09900-25008: Multi circuit tester
V Tester knob indication: Voltage (
No
Yes
Black or Green wire open or shorted to ground, or poor Z or
c connection. ( 4-25)
If wire and connection are OK, intermittent trouble or faulty ECM.
Recheck each terminal and wire harness for open circuit and
poor connection. ( 4-4)
(Black – Green)
∞Ω (Infinity) ∞Ω ∞Ω ∞Ω
( Black – Ground
Green – Ground
No Replace the CKP sensor
with a new one.
(Black – Green)
)
Loose or poor contacts on the CKP
sensor coupler or ECM coupler.
Replace the CKP sensor with a
new one.
Replace the ECM with a new one,
and inspect it again.
FI SYSTEM AND INTAKE AIR SYSTEM 4-35
POSSIBLE CAUSE
• Metal particles or foreign material being
attached on the CKP sensor and rotor tips.
• CKP sensor circuit open or short.
• CKP sensor malfunction.
• ECM malfunction.
1
)
2
Green Grees Black Black
V
Peak volt adaptor Peak volt adaptor
ECM couplers