F Code (Using F Code Transmission) - Fuji Xerox ApeosPort-IV 5070 User Manual

4 Fax
Folder Passcode
Select the [Folder Passcode] box, and enter the 4-digit passcode of the remote folder
using the numeric keypad. If a passcode is not set, leave this box blank.
Format for Auto Send (DTMF Method)
1
Select [New Recipients] on the [Fax/Internet] screen to display the keyboard on the
touch screen, and enter the destination and passcode in the following format.
Format for Manual Send (DTMF Method)
1
Select [On-hook (Manual Send/Receive)] on the [More Options] screen to display the
keyboard on the touch screen, and enter the destination and passcode in the following
format.
4
Note
By registering destinations in address numbers using the above dialing formats, you can use the address
numbers for the Secure Polling feature. For information on how to register address numbers, refer to "5
Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.

F Code (Using F Code Transmission)

F Code is the transmission procedure set by the Communications and Information
Network Association of Japan and is the T.30 (communication protocol) method for
using sub-addresses that was standardized by the ITU-T. The F Code feature enables
various features to be used with transmission among F Code-compatible machines
regardless of their manufacturers.
When using F Code transmission, use an F Code and password. The F Code, which is
also called a sub-address by other companies, must be registered (entered). Set a
password if necessary.
Note
You can set the F Code and password for each address number. For information on how to register
address numbers, refer to "5 Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.
You can use the Relay Broadcast and Remote Relay Broadcast features with F Code transmission. For
information on Relay Broadcast and Remote Relay Broadcast, refer to "Relay Broadcast (Transmitting
Documents Through a Relay Station)" (P.232) and "Remote Relay Broadcast (Performing Relay
Broadcast to Remote Locations)" (P.235), respectively.
218
• Use the keyboard on the touch screen to enter symbols such as "!" and "∗". For information
on how to enter characters, refer to "Entering Text" (P.68).
• Enter a passcode only if necessary.
• You can specify any machine that supports our DTMF method feature.
• This feature is not available for the Server Fax service except when an F code is included in
the dialing number.
• To use the F Code feature, you need to confirm the F Code of the recipient's machine in
advance.
• If you perform Sending to Folder or Secure Polling between machines of this model, we
recommend that you use the fax signal method.