Step 4 Starting The Fax Job - Fuji Xerox ApeosPort-IV 5070 User Manual

2
To specify multiple recipients, select [+ Add]
on the touch screen.
Note • If you have entered an incorrect value,
• Depending on the settings, a screen to re-
For information how to specify a fax number using the Address Book, refer to "Specifying a Destination
Using the Address Book" (P.188).
For information how to specify a fax number using speed dialing, refer to "Speed Dialing (Specifying a
Destination Using an Address Number)" (P.190).
For information how to specify a fax number using one touch buttons, refer to "Specifying a Destination
Using a One Touch Button" (P.191).
For information on Internet Fax, refer to "About Internet Fax" (P.165).
For information on IP Fax (SIP), refer to "About IP Fax (SIP)" (P.173).

Step 4 Starting the Fax Job

The following describes how to start a fax job.
1
Press the <Start> button.
Important • If the document has been loaded in the
• A fax cannot be sent if a copy protection
Note • Depending on the settings, the screen to
• If a problem occurs, an error message
If you have more documents
If you have more documents to fax, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to send the documents as one set
of data.
press the <C (Clear)> button and enter
the correct value.
enter the recipient may be displayed after
you specify the recipient and then select
[+ Add]. In such case, re-enter the
recipient.
document feeder, do not hold down the
document while it is being conveyed.
code is detected.
re-enter the recipient may be displayed
after pressing the <Start> button. In this
case, re-enter the recipient.
appears on the touch screen. Follow the
instructions of the message to solve the
problem.
Fax Procedure
1 2 3
4 5 6
7 8 9
0 #
C
<Start> button
159
4