Fuji Xerox ApeosPort-IV 5070 User Manual page 247

1
Remove any paper clips and staples before loading a document.
2
Load the document face up (when the
document is 2-sided, place the front side up)
in the center of the document feeder.
Note • Normally, load the document in the
• The confirmation indicator lights up when
3
Adjust the document guides to match the
size of the document loaded.
4
Raise the document stopper.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with
sizes from 15 x 15 mm to 297 x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard
size documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically and how to enter a non-standard
document size, refer to "Original Size (Specifying a Scan Size)" (P.307).
The standard document sizes that can be detected automatically depend on the [Paper Size Settings]
made in System Administration mode. For information on the paper size settings, refer to "5 Tools" >
"Common Service Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
CAUTION
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
[Sideways Images] orientation. The
document is displayed in the [Upright
Images] orientation when viewed on a
computer.
the document is loaded correctly. If the
indicator does not light, the machine may
be detecting a document on the document
glass. Load the document again.
Scanning Procedure
Confirmation indicator
247
5