Energy Saver Mode - Fuji Xerox ApeosPort-IV 5070 User Manual

Energy Saver Mode

The machine is equipped with an Energy Saver mode that saves electricity by reducing
the power consumption when no copy or print data is received for a specified time.
The Energy Saver feature has two modes: Low Power mode and Sleep mode.
The machine enters Low Power mode after the preset time has elapsed if the machine
is left unused for a fixed period of time.
The machine then enters Sleep mode if a further preset time elapses.
To enter Energy Saver mode, press the <Energy Saver> button on the control panel.
Low Power Mode
In this mode, the power to the control panel and fusing unit is lowered to save power.
The touch screen goes out, and the <Energy Saver> button on the control panel lights
up. To use the machine, press the <Energy Saver> button. The <Energy Saver> button
goes out to indicate that Low Power mode is exited.
Sleep Mode
In this mode, the power supply to devices such as the hard disk drive is suspended and
the power is lowered more than in Low Power mode.
The touch screen goes out, and the <Energy Saver> button on the control panel lights
up. To use the machine, press the <Energy Saver> button. The <Energy Saver> button
goes out to indicate that the Sleep mode is exited.
Sleep mode requires more time for the machine to exit and to be ready for use than
Low Power mode.
Note • When you press the <Energy Saver> button during Energy Saver mode, the touch screen
• When you make the machine exit Energy Saver mode by pressing the <Energy Saver>
• If you replace toner cartridges or supply paper during Energy Saver mode, the machine
• Energy Saver mode is not exited by the following operations:
• When the following device is connected to the machine and a user performs the following
• When the machine enters the Low Power mode while a user is authenticated, the machine
lights up. At this point, the document scanning unit and the output devices remain in Energy
Saver mode. Afterwards, by operations such as using the touch screen and opening or
closing of the document cover, you can make the devices necessary to activate the machine
to exit Energy Saver mode and make the machine ready to start exiting Energy Saver mode.
button, the machine does not immediately identify the movements such as opening or
closing of the front cover. To make the machine identify these operations, operate the
control panel before opening the front cover.
does not identify these changes. Before performing these operations, exit Energy Saver
mode by first pressing the <Energy Saver> button on the control panel and then pressing the
<Machine Status> button.
• Secure print
• Fax using Folder Receive
• Direct fax
• Accessing a folder of the machine using CentreWare Internet Services
operation, Low Power mode can be deactivated without pressing the <Energy Saver>
button. If the machine is in Sleep mode, however, Sleep mode will not be deactivated by the
operation. By setting longer time to elapse until the machine enters Sleep mode, you can
make the machine exit Energy Saver mode without pressing the <Energy Saver> button. For
more information on how to change the time to elapse until the machine enters Sleep mode,
refer to "1 Before Using the Machine" > "Energy Saver Mode" > "Changing the Interval for
Entering Energy Saver Mode" in the Administrator Guide.
• Placing a smart card on the IC Card Reader (optional)
exits the authentication mode.

Energy Saver Mode

2
57