Sending An Ip Fax (Sip); Receiving An Ip Fax (Sip) - Fuji Xerox ApeosPort-IV 5070 User Manual

Sending an IP Fax (SIP)

The following describes the procedure of sending IP Fax (SIP).
1
Select [IP Fax (SIP)].
2
Configure features as necessary.
For available features, refer to "Fax/Internet Fax" (P.186).
3
Specify a recipient.
Example:
Telephone number: 0312345678
SIP user name: 1111
SIP device address: 1111@192.168.1.1
Important • The method to input the IP Fax (SIP) destination differs depending on the fax type of the recipient
• Check the recipient information before sending the fax.
For the method to specify a recipient using the keyboard, refer to "Entering Text" (P.68).
For other methods to specify a recipient, refer to "Fax/Internet Fax" (P.186).
For broadcast sending, refer to "Broadcast" (P.231).
4
Press the <Start> button.
Important • If the document has been loaded in the
• A fax cannot be sent if a copy protection
Note • Depending on the settings, a screen to
• If a problem occurs, an error message
If a fax cannot be sent, refer to "15 Problem Solving" > "Trouble during Faxing" in the Administrator
Guide.
For the method to cancel sending a fax, refer to "Stopping the Fax Job" (P.162).

Receiving an IP Fax (SIP)

Received fax documents are printed automatically in a manner similar to that of a reg-
ular fax.
For information on operations of the Remote Folder, refer to "Receiving Faxes" (P.239).
or the connection configuration. For these differences, refer to "About IP Fax (SIP)" (P.173).
document feeder, do not hold down the
document while it is being conveyed.
code is detected.
re-enter the recipient may be displayed
after you specify the recipient. In such
cases, re-enter the recipient.
appears on the touch screen. Follow the
instructions of the message to solve the
problem.
About IP Fax (SIP)
1 2 3
4
5 6
7 8 9
0 #
C
<Start> button
177
4