Store To Usb - Fuji Xerox ApeosPort-IV 5070 User Manual

Store to USB

This section describes the procedure to select features on the [Store to USB] screen.
The Store to USB service allows you to scan documents and save the scanned data to
a USB memory device. The following describes features available on the [Store to
USB] tab.
Save in (Specifying a Storage Location in the USB Memory Device).................................... 290
Details (Displaying the Details of a Storage Location in the USB Memory Device).............. 291
Preview (Previewing the Scanned Images during a Scan Job) ................................................ 292
Color Scanning (Selecting an Output Color) ........................................................................... 292
2 Sided Scanning (Scanning Both Sides of a Document) ........................................................ 292
Original Type (Selecting the Document Type) ........................................................................ 292
File Format (Selecting a File Format for Output Data)............................................................ 292
Important • Before removing the USB memory device, make sure that the screen indicating that data is
Note • This feature may not be available depending on the setting in CentreWare Internet Services.
• An optional component is required to use this service. For more information, contact our
• A USB memory device encrypted with software is not supported.
• The following USB memory devices can be used:
• You can use a commercially available single-slot
You can customize the layout of the features displayed on the [Store to USB] screen. For more
information, refer to "5 Tools" > "Scan Service Settings" > "First Tab" in the Administrator Guide.
1
Insert the USB memory device into the USB memory slot on the control panel.
2
One of the following occurs.
The [USB Device Detected] screen appears.
The [Store to USB] screen appears.
The [Media Print - Text] screen appears.
The screen display does not change.
Note • The behavior depends on the settings. Ask your system administrator for more information.
• When a USB memory device is inserted into the USB memory slot during Energy Saver
being transferred is not displayed. If you remove the USB memory device while data is being
stored, the data in the device may be damaged. You can also view the [Job Status] screen
to confirm if the data has been stored to the USB memory device.
For more information, refer to "6 CentreWare Internet Services Settings" > "Configuring
Machine Settings Using CentreWare Internet Services" in the Administrator Guide.
Customer Support Center.
• A formatted USB memory device
• A USB 2.0 compliant memory device (USB 1.1 is not supported.)
• A USB memory device with a storage capacity of up to 128 GB
is not guaranteed. When you use a multi-slot
can be recognized. The slot to be used differs depending on the card readers. Some of the
media and slots of Memory Card Readers may not be used on the machine, and the
operation is not guaranteed.
*1: Media/Memory Card Reader that has one slot. Some allow only one type of media/
Memory Card, while others allow more than one types (ex. SD card, xD-Picture
Card).
*2: Media/Memory Card Reader that has two or more slots.
mode, the touch screen does not light up. After exiting Energy Saver mode by pressing the
<Energy Saver> button, insert the USB memory device again or select the [Store to USB] on
the [Services Home] screen. For information on other ways to exit Energy Saver mode, refer
to "Exiting Energy Saver Mode" (P.58).
*1
Memory Card Reader, but the operation
*2
Memory Card Reader, only one of those slots

Store to USB

5
287