Cutter Holder Height Adjustment; Jigs And Tools; Adjustment Procedure - MUTOH ValueJet VJ-1324 Maintenance Manual

4.8 Cutter Holder Height Adjustment

4.8 Cutter Holder Height Adjustment
This section describes the procedure to adjust cutter holder height.
4.8.1

Jigs and Tools

• Cutter Holder adjustiment Jig: DG-43191
T I P
"7.4 Jigs and Tools" p.7-6

Adjustment Procedure

4.8.2
1. Remove Carriage Cover.
"3.7.2 Removing Carriage Cover" p.3-99
2. Release the Carriage Lock.
"3.7.1 How To Release Carriage Lock" p.3-98
3. Remove Photometer JUNCTION Board Assy.
"3.7.13 Replacing Photometer JUNCTION Board Assy" p.3-128
4. Loosen the screws (2 pieces) retaining Cutter Holder.
4
No.
1 PG adjustment Lever
4.8.1 Jigs and Tools
1
3
Name
2
Spring
3
Pan-head screw with spring washer and flat washer M3 × 8 Ni-3
4 Cutter Holder
5. Using dedicated Jig to assemble Cutter Holder .
Set dedicated Jig on mounting position.
No.
1 Cutter Holder R
2 Dedicated Jig
6. Push Cutter Holder down lightly to tighten the screws.
2
7. To reassemble unit, reverse the removal procedure.
Turn on cutter to check if it cuts paper properly.
8.
"5.12.3 Cutter Endurance Menu" p.5-74
VJ1324E-M-02
Name
Push Cutter Holder down
lightly to tighten the
screws.
P.4-15