Sensor (Exit 2) On Jam In Standard Bin Or Finisher - Lexmark X850e Service Manual

203.02 Sensor (exit 2) on jam in standard bin or finisher

Step
1 Check the position of the media diverter solenoid.
Is the media diverter gate facing toward exit 1?
2 Check the media diverter gate for an obstruction.
Is the media diverter gate free of any debris or
obstructions?
3 Check the diverter solenoid for proper operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Printer Motor Test.
4. Touch Diverter solenoid.
Open the printer left door assembly.
Does the above component operate normally?
4 Check the media diverter solenoid for proper
connection.
Is the above component connected properly?
5 Check the media position.
Open the exit 2 left door assembly, and visually check it.
Does the media touch the sensor (exit 2)?
6 Check the sensor (exit 2) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch BASE SENSOR TEST.
3. Touch Media Path.
4. Touch Exit2.
Open the printer left door assembly and the exit 2 left
door assembly.
Does the display on the operator panel change every
time the actuator on the above sensor operates?
7 Check the sensor (exit 2) for proper connection.
Is the above sensor connected properly?
8 Perform a print test.
Does the error still occur?
Check Yes
Go to step 2. Go to step 3.
Remove any Go to step 3.
obstructions.
Go to step 5. Go to step 3.
Replace the exit 2 Replace the
unit assembly. connection.
Go to "Exit 2 unit
assembly removal"
on page 4-315.
Remove the media. Go to step 6.
Go to step 8. Go to step 7.
Replace the sensor Replace the
(exit 2). connection.
Go to "Exit 2
sensor (exit 2)
removal" on
page 4-328.
Replace the exit Problem solved.
interface card
assembly.
Go to "Exit
interface card
assembly removal"
on page 4-116.
Go to step 9.
Diagnostic information
7500-XXX
No
2-49