D-Link DGS-3224TGR Command Line Interface Reference Manual page 95

config igmp_snooping
Purpose Used to configure IGMP snooping on the switch.
Syntax config igmp_snooping [<vlan_name 32>|all] {host_timeout <sec 1-
16711450>|router_timeout <sec 1-16711450>|leave_timer <sec 1-16711450>|state
[enable|disable]} fast_leave [enable|disable]
Description This command allows you to configure IGMP snooping on the switch.
Parameters <vlan_name 32> − The name of the VLAN for which IGMP snooping is to be configured.
host_timeout <sec 1-16711450> − Specifies the maximum amount of time a host can be a
member of a multicast group without the switch receiving a host membership report. The
default is 260 seconds.
router_timeout <sec 1-16711450> − Specifies the maximum amount of time a route will
remain in the switch's can be a member of a multicast group without the switch receiving a
host membership report. The default is 260 seconds.
leave_timer <sec 1-16711450> − Leave timer. The default is 2 seconds.
state [enable|disable] − Allows you to enable or disable IGMP snooping for the specified
VLAN.
fast_leave [enable|disable] − This enables or disables the IGMP snooping fast_leave
function. If enabled, the membership is immediately removed when the system receives the
IGMP leave message.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure the IGMP snooping:
DGS-3224TGR:4#config igmp_snooping default host_timeout 250 state
enabled fast_leave enable
Command: config igmp_snooping default host_timeout 250 state enabled
fast_leave enable
Success.
DGS-3224TGR:4#
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
91