D-Link DGS-3224TGR Command Line Interface Reference Manual page 87

create link_aggregation group_id
Purpose Used to create a link aggregation group on the switch.
Syntax create link_aggregation group_id <value 1-32>(type [lacp|static]}
This command will create a link aggregation group.
Description
<value 1-32> − Specifies the group id. The switch allows up to 32 link aggregation groups to
Parameters
be configured. The group number identifies each of the groups.
type [lacp|static] – Indicates the group type belongs to static or lacp. If type is not specified,
the default is static.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To create link aggregation group:
DGS-3224TGR:4#create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DGS-3224TGR:4#
delete link_aggregation group_id
Purpose Used to delete a previously configured link aggregation group.
Syntax delete link_aggregation group_id <value 1-32>
Description This command is used to delete a previously configured link aggregation group.
<value 1-32> − Specifies the group ID. The switch allows up to 32 link aggregation groups to
Parameters
be configured. The group number identifies each of the groups.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To delete link aggregation group:
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
DGS-3224TGR:4#delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DGS-3224TGR:4#
83