D-Link DGS-3224TGR Command Line Interface Reference Manual page 90

config lacp_ports
Used to configure the current mode of LACP for specified ports.
Purpose
Syntax config lacp_ports <portlist> mode [active|passive]
Description This command configures per-port LACP mode.
Parameters <portlist> − Specifies a range of ports to be configured. The beginning and end of the port list
range are separated by a dash. For example, 3 would specify port 3. 4 specifies port 4. 1-4
specifies all of the ports between port 1 and port 4 − in numerical order.
mode [active|passive] − If neither active or passive is specified, the system will display the current
LACP status for all ports.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure ports for LACP:
DGS-3224TGR:4#config lacp_port 1-12 mode active
Command: config lacp_port 1-12 mode active
Success.
DGS-3224TGR:4#
show lacp_ports
Purpose Used to display the current mode of LACP ports.
Syntax show lacp_ports <portlist>
Description This command will display per-port LACP mode.
<portlist> − Specifies a range of ports to be configured. If no parameter is specified, the
Parameters
system will display the current LACP status of all ports. The beginning and end of the port list
range are separated by a dash. For example, 3 would specify port 3. 4 specifies port 4. 1-4
specifies all of the ports between port 1 and port 4 − in numerical order.
Restrictions None.
Example Usage:
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
DGS-3224TGR:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source
Group ID : 1
Type : TRUNK
Master Port : 10
Member Port : 5-10
Active Port :
Status : Disabled
Flooding Port : 0
DGS-3224TGR:4#
86