D-Link DGS-3224TGR Command Line Interface Reference Manual page 107

config 802.1x auth_protocol
Used to configure the 802.1x authentication protocol on the switch.
Purpose
Syntax config 802.1x auth_protocol [local|radius_eap]
Description The config 802.1x auth_protocol command enables you to configure the authentication
protocol.
Parameters local|radius_EAP – Specify the type of authentication protocol desired.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure 802.1x authentication protocol:
DGS-3224TGR:4#
Command: config 802.1x auth_protocol radius_eap
Success.
DGS-3224TGR:4#
config 802.1x capability
Purpose Used to configure the 802.1x capability of a range of ports on the switch.
Syntax config 802.1x capability ports [<portlist>|all] [authenticator|none]
The config 802.1x command has two capabilities that can be set for each port: Authenticator
Description
and None.
<portlist> − Specifies a range of ports. The port list is specified by listing the beginning port
Parameters
number and the highest port number of the range. The beginning and end of the port list
range are separated by a dash. For example, 3 would specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and port 4 − in numerical order.
all − Specifies all of the ports on the switch.
authenticator − A user must pass the authentication process to gain access to the network.
none − The port is not controlled by the 802.1x functions.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure 802.1x capability on ports 1-10:
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
config 802.1x auth_protocol radius_eap
config 802.1x capability ports 1 – 10 authenticator
DGS-3224TGR:4#
Command: config 802.1x capability ports 1-10 authenticator
Success.
DGS-3224TGR:4#
103