D-Link DGS-3224TGR Command Line Interface Reference Manual page 170

reconfig
Syntax
Description
Parameters
Restrictions
Example usage:
To connect to the MS, with member id 2, through the CS, using the command line interface:
DGS-3224TGR:4#reconfig member_id 2
Command: reconfig member_id 2
DGS-3224TGR:4#
config sim_group
Purpose
Syntax
Description
Parameters
Restrictions
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
reconfig {member_id <value 1-32 | exit}
This command is used to reconnect to a member switch using telnet.
member_id <value 1-32> - Select the ID number of the member
switch the user desires to configure.
exit – This command is used to exit from managing the member
switch and will return to managing the commander switch.
Only administrator-level users can issue this command.
Used to add candidates and delete members from the SIM group.
config sim_group [add <candidate_id 1-100> {<password>} |
delete <member_id 1-32>]
This command is used to add candidates and delete members from
the SIM group by ID number.
add <candidate_id 1-100> <password> - Use this parameter to
change a candidate switch (CaS) to a member switch (MS) of a SIM
group. The CaS may be defined by its ID number and a password (if
necessary).
delete <member_id 1-32> - Use this parameter to delete a member
switch of a SIM group. The member switch should be defined by it ID
number.
Only administrator-level users can issue this command.
166