D-Link DGS-3224TGR Command Line Interface Reference Manual page 82

config gvrp
Only administrator-level users can issue this command.
Restrictions
Example Usage:
To sets the ingress checking status and the GVRP status:
DGS-3224TGR:4#config gvrp 1-5 state enable ingress_checking enable
pvid 2
Command: config gvrp 1-5 state enable ingress_checking enable pvid 2
Success.
DGS-3224TGR:4#
enable gvrp
Used to enable GVRP on the switch.
Purpose
Syntax enable gvrp
Description This command, along with disable gvrp below, is used to enable and disable GVRP on the
switch − without changing the GVRP configuration for each port on the switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To enable the generic VLAN Registration Protocol (GVRP):
DGS-3224TGR:4#enable gvrp
Command: enable gvrp
Success.
DGS-3224TGR:4#
disable gvrp
Purpose Used to disable GVRP on the switch.
Syntax disable gvrp
Description This command, along with disable gvrp below, is used to enable and disable GVRP on the
switch − without changing the GVRP configuration for each port on the switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To disable the Generic VLAN Registration Protocol (GVRP):
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
78