D-Link DGS-3224TGR Command Line Interface Reference Manual page 39

Example Usage:
To turn off SNMP authentication trap support:
DGS-3224TGR:4#disable snmp authenticate traps
Command: disable snmp authenticate traps
Success.
DGS-3224TGR:4#
ping
Purpose Used to test the connectivity between network devices.
Syntax ping <ipaddr> {times <value>} {timeout <sec>}
This command sends Internet Control Message Protocol (ICMP) echo messages to a remote
Description
IP address. The remote IP address will then "echo" or return the message. This is used to
confirm connectivity between the switch and the remote device.
<ipaddr> − The IP address of the remote device.
Parameters
times <value> − The number of individual ICMP echo messages to be sent. A value of 0 will
send an infinite ICMP echo messages. The maximum value is 255. The default is 0.
timeout <sec> − defines the time-out period while waiting for a response from the remote
device. A value of 1 to 99 seconds can be specified. The default is 1 second.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To send ICMP echo message to "10.48.74.121" for 4 times:
DGS-3224TGR:4#ping 10.48.74.121 times 4
Command: ping 10.48.74.121
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Reply from 10.48.74.121, time<10ms
Ping Statistics for 10.48.74.121
Packets: Sent =4, Received =4, Lost =0
DGS-3224TGR:4#
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
35