D-Link DGS-3224TGR Command Line Interface Reference Manual page 88

config link_aggregation
Purpose Used to configure a previously created link aggregation group.
Syntax config link_aggregation group_id <value 1-32> {master_port <port>|ports <portlist>|
state [enable|disable]
Description This command allows you to configure a link aggregation group that was created with the
create link_aggregation command above.
<value 1-32> − Specifies the group id. The switch allows up to 32 link aggregation groups to
Parameters
be configured. The group number identifies each of the groups.
<port> − Master port ID. Specifies which port (by port number) of the link aggregation group
will be the master port. All of the ports in a link aggregation group will share the port
configuration with the master port.
<portlist> − Specifies a range of ports that will belong to the link aggregation group. The
beginning and end of the port list range are separated by a dash. For example, 3 would
specify port 3. 4 specifies port 4. 1-4 specifies all of the ports between port 1 and port 4 − in
numerical order.
state [enable|disable] − Allows you to enable or disable the specified link aggregation group.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To define a load-sharing group of ports, group-id 1, master port 10:
DGS-3224TGR:4#config link_aggregation group_id 1 master_port
10 ports 5-10
Command: config link_aggregation group_id 1 master_port 10
ports 5-10
Success.
DGS-3224TGR:4#
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
84