D-Link DGS-3224TGR Command Line Interface Reference Manual page 89

config link_aggregation algorithm
Purpose Used to configure the link aggregation algorithm.
Syntax config link_aggregation algorithm [mac_source|mac_destination|mac_source_dest|
ip_source|ip_destination|ip_source_dest]
Description This command configures to part of the packet examined by the switch when selecting the egress
port for transmitting load-sharing data. This feature is only available using the address-based
load-sharing algorithm.
mac_source − Indicates that the switch should examine the MAC source address.
Parameters
mac_destination − Indicates that the switch should examin the MAC destination address.
mac_source_dest − Indicates that the switch should examine the MAC source and ddestination
addresses
ip_source − Indicates that the switch should examine the IP source address.
ip_destination − Indicates that the switch should examine the IP destination address.
ip_source_dest − Indicates that the switch should examine the IP source address and the
destination address.
Only administrator-level users can issue this command.
Restrictions
Example Usage:
To configure link aggregation algorithm for mac-source-dest:
DGS-3224TGR:4#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
DGS-3224TGR:4#
show link_aggregation
Used to display the current link aggregation configuration on the switch.
Purpose
Syntax show link_aggregation {group_id <value 1-32>|algorithm}
Description This command will display the current link aggregation configuration of the switch.
Parameters <value 1-32> − Specifies the group id. The switch allows up to six link aggregation groups to
be configured. The group number identifies each of the groups.
algorithm − Allows you to specify the display of link aggregation by the algorithm in use by
that group.
None.
Restrictions
Example Usage:
To show link aggregation:
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
85