D-Link DGS-3224TGR Command Line Interface Reference Manual page 27

show config
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show all system configurations from DRAM database:
DGS-3224TGR:4#show config dram
Command: show config dram
# BASIC
config serial_port baud_rate 9600 auto_logout 10_minutes
enable telnet 23
enable web 80
disable jumbo_frame
# STP
config stp maxage 20 hellotime 2 dorwarddelay 15 priority 32768 version rstp
txholdcount 3 fbpdu enabled
disable stp
config stp ports 1-24 cost auto priority 128 edge false p2p auto state enabled
# LACP
config link_aggregation algorithm mac_source
config lacp_port 1-24 mode passive
# STORM
config traffic control 1-24 broadcast disable threshold
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
DGS-3224TGR:4#show realtime
Command: show realtime
The current time : 2003/09/23 11:00:59
DGS-3224TGR:4#
Used to collect and show all system configurations in a single CLI command.
show config [dram|flash]
This command displays all system configurations. The continuous display
configuration can be aborted by an interrupt key, which may be a sequential
keying process or a single key. The display format should be the same as the
CLI configuration command.
dram – Show system configuration from DRAM database. This is the current
system setting.
flash – Show system configuration from NVRAM.
Only administrator-level users can issue this command.
23