D-Link DGS-3224TGR Command Line Interface Reference Manual page 109

config 802.1x init
Used to initialize the 802.1x functions on a range of ports.
Purpose
Syntax config 802.1x init [port_based [<portlist>|all] |mac_based[<portlist>|all] {mac_address
<macaddr>}]
The config 802.1x init command is used to immediately initialize the 802.1x functions on a
Description
range of ports.
Parameters port_based – Configure the authentication as port-based mode.
mac_based – Configure the authentication as MAC-based mode.
<portlist> − Specifies a range of ports. The port list is specified by listing the beginning port
number and the highest port number of the range. The beginning and end of the port list
range are separated by a dash. For example, 3 would specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and port 4 − in numerical order.
all − Specifies all of the ports on the switch.
mac_address − MAC address of client.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To initialize 802.1x port-based functions on ports 15 to 18:
config 802.1x reauth
Purpose Used to configure the 802.1x re-authentication feature of the switch.
Syntax config 802.1x reauth [port_based [<portlist>|all] |mac_based[<portlist>|all]
{mac_address <macaddr>}]
Description The config 802.1x reauth command is used to enable the 802.1x re-authentication feature on
the switch.
port_based – Switch pass data based on its authenticated port.
Parameters
mac_based – Switch pass data based on MAC addess of authenticated RADIUS client.
<portlist> − Specifies a range of ports. The port list is specified by listing the beginning port
number and the highest port number of the range. The beginning and end of the port list
range are separated by a dash. For example, 3 would specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and port 4 − in numerical order.
all − Specifies all of the ports on the switch.
mac_address − MAC address of authenticated RADIUS client.
Restrictions Only administrator-level users can issue this command.
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
config 802.1x init port-based 15-18
DGS-3224TGR:4#
Command: config 802.1x init port-based 15-18
Success.
DGS-3224TGR:4#
105