D-Link DGS-3224TGR Command Line Interface Reference Manual page 108

config 802.1x auth_parameter
Used to configure the 802.1x Authentication parameters on a range of ports. The default
Purpose
parameter will return all ports in the specified range to their default 802.1x settings.
Syntax config 802.1x auth_parameter ports [<portlist>|all] [default|{direction
[both|in]|port_control [force_unauth|auto|force_auth]| quiet_period <sec 0-65535>|
max_req <value 1-10>|reauth_period <sec 1-65535>|enable_reauth
[enabled|disabled]}]
Description The config 802.1x auth_parameter command is used to configure the 802.1x Authentication
parameters on a range of ports. The default parameter will return all ports in the specified
range to their default 802.1x settings.
Parameters
<portlist> − Specifies a range of ports. The port list is specified by listing the beginning port
number and the highest port number of the range. The beginning and end of the port list
range are separated by a dash. For example, 3 would specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and port 4 − in numerical order.
all − Specifies all of the ports on the switch.
default − Returns all of the ports in the specified range to their 802.1x default settings.
direction [both|in] − Determines whether a controlled port blocks communication in both the
receiving and transmitting directions, or just the receiving direction.
port_control − Configures the administrative control over the authentication process for the
range of ports.
Only administrator-level users can issue this command.
Restrictions
Example Usage:
To configure 802.1x authentication parameters for ports 1 to 20:
DGS-3224TGR:4#
Command: config 802.1x auth_parameter ports 1-20 direction both
Success.
DGS-3224TGR:4#
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
force_auth − Forces the Authenticator for the port to become authorized. Network access
is allowed.
auto − Allows the port's status to reflect the outcome of the authentication process.
force_unauth − Forces the Authenticator for the port to become unauthorized. Network
access will be blocked.
quiet_period <sec 0-65535> − Configures the time interval between authentication failure
and the start of a new authenticaiton attempt.
max_req <value 1-10> − Configures the number of times to retry sending packets to a
supplicant (user).
reauth_period <sec 1-65535> − Configures the time interval between successive re-
authentications.
enable_reauth [enabled|disabled] − Determines whether or not the switch will re-
authenticate. Enabled causes re-authentication of users at the time interval specified in
the Re-authentication Period field, above.
config 802.1x auth_parameter ports 1 – 20 direction both
104