D-Link DGS-3224TGR Command Line Interface Reference Manual page 159

config login_authentication response_timeout
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the response timeout for 60 seconds:
DGS-3224TGR:4#config login_authentication response_timeout 60
Command: config login_authentication response_timeout 60
Success.
DGS-3224TGR:4#
config login_authentication attempt
Purpose
Syntax
Description
Parameters
Restrictions
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
Used to configure the amount of time the Switch will wait for a user
to enter authentication before timing out.
config login_authentication response_timeout <int 1-255>
This command will set the time the Switch will wait for a response of
authentication from the user.
response_timeout <int 1-255> - Set the time, in seconds, the Switch
will wait for a response of authentication from the user attempting to
log in from the command line interface or telnet interface. An entry of
0 will denote that the Switch will never time out while waiting for a
response of authentication. The default setting is 30 seconds.
Only administrator-level users can issue this command.
Used to configure the maximum number of times the Switch will
accept authentication attempts.
config login_authentication attempt <int 1-255>
This command will configure the maximum number of times the
Switch will accept authentication attempts. Users failing to be
authenticated after the set amount of attempts will be denied
access to the Switch and will be locked out of further authentication
attempts. Command line interface users will have to wait 60
seconds before another authentication attempt. Telnet users will be
disconnected from the Switch.
parameter attempt <int 1-255> - Set the maximum number of
attempts the user may try to become authenticated by the Switch,
before being locked out. The default setting is 3 attempts.
Only administrator-level users can issue this command.
155