D-Link DGS-3224TGR Command Line Interface Reference Manual page 19

config serial_port
Used to configure the serial port.
Purpose
Syntax config serial_port {baud_rate[9600|19200|38400|115200]|auto_logout
[never|2_minutes|5_minutes|10_minutes| 15_minutes]}
This command is used to configure the serial port's baud rate and auto logout settings.
Description
[9600|19200|38400|115200] − The serial bit rate that will be used to communicate with the
Parameters
management host.
never − No time limit on the length of time the console can be open with no user input.
2_minutes − The console will log out the current user if there is no user input for 2 minutes.
5_minutes − The console will log out the current user if there is no user input for 5 minutes.
10_minutes − The console will log out the current user if there is no user input for 10 minutes.
15_minutes − The console will log out the current user if there is no user input for 15 minutes.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure baud rate:
enable jumbo_frame
Used to enable support for Jumbo Frames.
Purpose
Syntax enable jumbo_frame
Description This command is used to enable support for Jumbo Frames up to 9216 bytes.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To enable jumbo frame support on the switch:
DGS-3224TGR:4#enable jumbo_frame
Command: enable jumbo_frame
Success.
DGS-3224TGR:4#
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
DGS-3224TGR:4#config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
Success.
DGS-3224TGR:4#
15