Show Interface Command; Show Port Command - Avaya P333R-LB User Manual

Show interface Command

Use the show interface command to display information on network
interfaces.
The syntax for this command is:
show interface
Example:
To display the interface:
P330-N> show interface
Interface Name
--------------
inband
ppp disable

Show port Command

Use the show port command to display port status.
The syntax for this command is:
show port [<mod_num>[/<port_num>]]
mod_num
port_num
Example:
To display the status for port 4 on module 3:
P330-N> show port 3/4
Port Name
------ --------------- --------- ---- ------ ------- ---- ---- -------------
3/4 John
Avaya P333R-LB User's Guide
VLAN IP address
---- ---------------
1 10.0.0.1
1 0.0.0.0
(Optional) Number of the module. If you do not specify a
number, the ports on all modules are shown.
(Optional) Number of the port on the module. If you do not
specify a number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, e.g.
5-13 for ports 5 to 13.
Status Vlan Level Neg
connected 1
Chapter 5 Cajun Campus CLI – Layer 2
Netmask
---------------
255.255.255.0
0.0.0.0
Dup. Spd. Type
4 enable half 10M 10/100Base-Tx
57