Show timeout Command
Use the show timeout command to display the amount of time the CLI can
remain idle before timing out in minutes. If the result is 0, there is no timeout limit.
The syntax for this command is:
show timeout
Example:
Cajun_P330-N> show timeout
CLI timeout is 10 minutes
Show interface Command
Use the show interface command to display information on network
interfaces.
The syntax for this command is:
show interface
Example:
To display the interface:
Cajun_P330-N> show interface
Interface Name
--------------
inband
ppp disable
Show port Command
Use the show port command to display port status.
The syntax for this command is:
show port [<mod_num>[/<port_num>]]
mod_num
port_num
Avaya P333T User's Guide
VLAN
IP address
----
---------------
1
10.0.0.1
1
0.0.0.0
(Optional) Number of the module. If you do not specify a
number, the ports on all modules are shown.
(Optional) Number of the port on the module. If you do not
specify a number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, e.g.
5-13 for ports 5 to 13.
Chapter 6
Cajun Campus CLI – Layer 2
Netmask
---------------
255.255.255.0
0.0.0.0
47