Chapter 5
Cajun Campus CLI – Layer 2
Show port flowcontrol Command
Use the show port flowcontrol command to display per-port status
information related to flow control.
The syntax for this command is:
show port flowcontrol [<mod_num>[/<port_num>]]
Example:
P330-N> show port flowcontrol 3/2
Port
------ ----- ----
3/2
Output Fields:
Field
Port
Send-
Flowcontrol-
Admin
Send-
Flowcontrol-
Oper
Receive-
Flowcontrol-
Admin
Receive-
Flowcontrol-
Oper
66
Send-Flowcontrol Receive-Flowcontrol
Admin Oper
off
off
Description
Module and port number
Send flow-control administration. Possible settings:
• ON indicates that the local port is allowed to send flow
control frames to the far end.
• OFF indicates that the local port is not allowed to send flow
control frames to the far end.
Send flow-control operation mode. Possible modes:
• ON indicates that the local port will send flow control frames
to the far end.
• OFF indicates that the local port will not send flow control
frames to the far end.
Receive flow-control administration. Possible settings:
• ON indicates that the local port will act upon flow control
indications if received from the far end.
• OFF indicates that the local port will discard flow control
frames if received from the far end.
Receive flow-control operation mode. Possible modes:
• ON indicates that the local port will act upon flow control
indications received from the far end.
• OFF indicates that the local port will discard flow control
frames received from the far end.
Admin Oper
----- ----
off
off
Avaya P333R-LB User's Guide