Chapter 3
Installation and Setup
Installing Expansion Sub-Modules
Caution: The expansion sub-modules contain components sensitive to electrostatic
discharge. Do not touch the circuit board unless instructed to do so.
Installing the Expansion Sub-Module into the P333R-LB
To install the expansion sub-module into the P333R-LB:
1
Remove the blanking plate or other sub-module (if installed).
2
Insert the sub-module gently into the slot, ensuring that the Printed Circuit
Board (PCB) is aligned with the guide rails. The PCB, not the metal base plate,
fits into the guide rail.
3
Press the sub-module in firmly until it is completely inserted into the P333R-LB.
4
Gently turn the two screws on the front panel of the expansion sub-module
until they are secure.
Removing an Existing Expansion Sub-Module
To remove an existing expansion sub-module:
1
Loosen the two screws on the front panel of the expansion sub-module.
2
Grasp the two knobs one near each side of the front panel, and pull gently but
firmly towards yourself.
3
Insert another expansion sub-module or the blanking plate.
Note: If an expansion sub-module is removed from the stack with the power supply
on, all configuration definitions on expansion sub-modules are lost. To remove an
expansion sub-module and save configuration definitions:
1
Turn off the power supply.
2
Remove an expansion sub-module.
3
Insert another expansion sub-module.
4
Turn on the power supply.
Note: The P333R-LB switch must not be operated with the expansion slot open. The
expansion sub-module slot should be covered with the supplied blanking plate if
necessary.
30
Avaya P333R-LB User's Guide