Show boot bank Command
Use the show boot bank command to display the Avaya P330 bank from which the
switch will boot on the next reset.
The syntax for this command is:
show boot bank
Example:
P330-N> show boot bank
Boot bank set to bank-b
Note: If this command is to be implemented on a module other than the stack
master, a session should be opened to the relevant module.
Show arp-tx-interval
Use the show arp-tx-interval command to display the keep-alive time.
The syntax for this command is:
show arp-tx-interval
Example:
P330-N> show arp-tx-interval
ARP tx interval is set to 5 seconds.
Show self-loop-discovery Command
Use the show self-loop-discovery command to display a module's IBM™ token ring
cable loop discovery status.
The syntax for this command is:
show self-loop-discovery [mod_num]
Example:
P330-N> show self-loop-discovery 1
Self-Loop-Discovery is disabled on module 1.
Avaya P333R-LB User's Guide
Chapter 5
Cajun Campus CLI – Layer 2
81