Establishing A Serial Connection; Establishing A Telnet Connection - Avaya P333R-LB User Manual
Stackable load balancing switch
Hide thumbs
Also See for P333R-LB:
- Application manual (10 pages) ,
- Quick start installation manual (38 pages) ,
- Installation and configuration manual (218 pages)
Table of Contents
Advertisement
Chapter 4
Cajun Campus CLI – Architecture, Access & Conventions
Establishing a Serial Connection
Perform the following steps to connect a terminal to the Avaya P330 Master Switch
Console port for configuration of Stack or Router parameters:
1
Use the serial cable supplied to attach the RJ-45 console connector to the
Console port of the Avaya P330 Master Switch. Connect the DB-9 connector to
the serial (COM) port on your PC/terminal.
2
Ensure that the serial port settings on the terminal are 9600 baud, 8 bits, 1 stop
bit and no parity.
3
When you are prompted for a Login Name, enter the default login. The default
login is root.
4
When you are promoted for a password, enter the user level password root.
5
Now you can establish a connection to the Router or the Master switch
(indicated when the SYS front panel LED is ON) using the Session commands
and begin the configuration of Module, Stack, or Router parameters.
Establishing a Telnet Connection
Perform the following steps to establish a Telnet connection to the Avaya P330 for
configuration of Stack or Router parameters. You can Telnet either the Stack Master
IP address or directly to one of the Router IP address:
1
Connect your station to the network.
2
Verify that you can communicate with the Avaya P330 using Ping to the IP of
the Avaya P330. If there is no response using Ping, check the IP address and
default gateway of both the Avaya P330 and the station.
Note: The Avaya P330 default IP address is 149.49.32.134 and the default subnet
mask is 255.255.255.0.
3
From the Microsoft Windows
from the DOS prompt of your PC), then start the Telnet session by typing:
telnet <P330_IP_address>
For example: telnet 192.168.35.214.
4
If the IP Address in Telnet command is the IP address of the stack, then
connection is established with the Switch CLI entity of the Master module.
If you want to connect to the Router CLI entity, use the session command.
If the IP address in the Telnet command is of the router, connection is
established to the Router CLI entity in the router module.
5
When you see the "Welcome to P330" menu and are prompted for a Login
Name, enter the default name root
40
®
taskbar of your PC click Start and then Run (or
Avaya P333R-LB User's Guide
Advertisement
Chapters
Table of Contents
