Assigning P333R-Lb Initial Parameters - Avaya P333R-LB User Manual
Stackable load balancing switch
Hide thumbs
Also See for P333R-LB:
- Application manual (10 pages) ,
- Quick start installation manual (38 pages) ,
- Installation and configuration manual (218 pages)
Table of Contents
Advertisement
Chapter 3
Installation and Setup
Assigning P333R-LB Initial Parameters
To start using the P333R-LB Routing options you must first assign IP addresses and
routing capabilities to the P333R-LB via the CLI.
1
To access Router commands from the Master module, type the command
session router; the command prompt changes from Console> to
Router> (see Avaya P330 Sessions on page 41).
2
Enter the command configure. The prompt Router(configure)#
appears.
3
Create the management/routing VLAN if the IP interface is not on VLAN #1.
Use the command set vlan <Vlan-id> name <Vlan-name>
4
Assign an IP interface name. Use the command:
Router(configure)# interface <interface-name>
5
Assign an IP interface address. Use the command:
Router(configure-if:<interface-name>)# ip address <ip-
address> <mask>
6
Assign the VLAN created in step 3 to the IP interface. Use the following
command:
Router(configure-if:<interface-name>)# ip vlan <Vlan-id> or
ip vlan name <Vlan-name>
7
Type exit. This returns you to the prompt: Router(configure)#
8
If the management station is not on the same subnet as the switch, configure a
default gateway (static route). Use the command:
ip default-gateway <ip-address>
9
To save the above configuration changes use the copy running-config
startup-config command.
Note: Once you have assigned an IP address/interface to the P333R-LB, you can either
configure the P333R-LB using the CajunView P330 Manager application or continue
using the CLI.
Note: You may want to remove the default gateway defined in Step 8, once you
have completed router configuration using CajunView or CLI.
38
Avaya P333R-LB User's Guide
Advertisement
Chapters
Table of Contents
