Show Interface Command; Set Interface Command; Show Log Command - Avaya P130 User Manual

Show interface Command

Use the show interface command to display information on the management
interfaces.
The syntax for this command is:
show interface [{ppp | inband}]
Example:
P130-N> show interface
Interface Name
--------------
inband
ppp

Set interface Command

Use the set interface command to configure the in-band interfaces on the
switch.
The syntax for this command is:
set interface [name][vlan][ip_addr][netmask]
name
vlan
ip_addr
netmask

Show log Command

Use the show log command to display Log files of all modules or of a specific
module.
The syntax for this command is:
show log [<module>[-<last module>]]
[<module>[-<last module>]]
Avaya P130 User's Guide
VLAN IP address
---- ---------------
1 149.49.34.211
1 0.0.0.0
Interface name ("inband" used for Master agent)
The number of the VLAN to be assigned to the interface
IP address
Subnet mask
One or more module numbers
Chapter 6 Avaya P130 CLI
Netmask
---------------
255.255.255.0
0.0.0.0
49