Show Arp-Aging-Interval Command; Show Snmp Command - Avaya P333R-LB User Manual

Show arp-aging-interval Command

Use the show arp-aging-interval to show the arp table aging interval for
gateways' entries.
The syntax for this command is:
show arp-aging-interval
Example:
P330-N(super)# show arp-aging-interval
ARP table aging interval for gateways was set to 10 minutes.

Show snmp Command

Use the show snmp command to display SNMP information.
The syntax for this command is:
show snmp
Example:
P330-N> show snmp
Authentication trap disabled
Community-Access
----------------
read-only
read-write
trap
Trap-Rec-Address
----------------
1.1.1.1
Avaya P333R-LB User's Guide
Chapter 5
Community-String
----------------
public
public
public
Traps Enabled
----------------
config
fault
etc...
Cajun Campus CLI – Layer 2
55