Chapter 5
Cajun Campus CLI – Layer 2
Example:
P330-N# set arp-tx-interval 15
ARP tx interval was set to 15 seconds.
Set self-loop-discovery Admin_status Command
Use the set self-loop-discovery Admin_Status command to enable or
disable IBM™ token ring cable loop discovery mode.
Note: You cannot configure set self-loop-discovery Admin_Status
(IBM™ Token Ring cable loop discovery mode) detection and LAG on the same
ports.
Note: Self loop discovery does not function when Spanning Tree is enabled.
Note: When the stack master is the P332G-ML or P332GT-ML, if this command is to
be implemented on a module in the stack, a session should be opened to the
relevant module.
The syntax for this command is:
set self-loop-discovery Admin_Status <enable|disable> <modul
num>
Example:
P330-N# set self-loop-discovery Admin_Status enable 1
Sync time Command
This command synchronizes the time used by all modules in a stack.
The syntax for this command is:
sync time
Example:
P330-N# sync time
Time has been distributed.
124
Avaya P333R-LB User's Guide