Set Ip Route Command; Set Arp-Aging-Interval Command - Avaya P333R-LB User Manual

Set ip route Command

Use the set ip route command to add IP addresses to the IP routing table. You
can configure from one to ten (10) default gateways for an Avaya P330 stack.
The syntax for this command is:
set ip route <destination> <gateway>
destination
gateway
Example:
This example shows how to add a default route to the IP routing table:
P330-N# set ip route
destination = 0.0.0.0
ROUTE NET TABLE
destination
------------------------------------------------------------------------
0.0.0.0
127.1.1.0
------------------------------------------------------------------------
ROUTE HOST TABLE
destination
------------------------------------------------------------------------
127.0.0.1
10.10.10.10
------------------------------------------------------------------------

Set arp-aging-interval Command

Use the set arp-aging-interval to set the arp table aging interval for
gateways' entries in the agent ARP table.
The syntax for this command is:
set arp-aging-interval <value>
value
Avaya P333R-LB User's Guide
IP address of the network, or specific host to be added
IP address of the router.
0.0.0.0 192.168.1.1
gateway = 192.168.1.1
gateway flags
192.168.1.1 1
127.1.1.1 1
gateway flags
127.0.0.1 5
192.168.1.1 7
The number representing the interval, from 0-10
minutes
Chapter 5 Cajun Campus CLI – Layer 2
Refcnt Use
1 3199
8 7606
Refcnt Use
2 131
0 0
Interface
se0
se1
Interface
lo0
se0
97