Chapter 5 Avaya Cli - Architecture, Access & Conventions; Establishing A Serial Connection - Avaya P333T User Manual

Chapter 5
–
Avaya CLI Architecture, Access & Conventions
This chapter describes the Avaya P330 CLI architecture and conventions, and
provides instructions for accessing the Avaya P330 for configuration purposes.
The configuration procedure involves establishing a Telnet session or a serial
connection and then using the Avaya P330's internal CLI. The CLI is command-line
driven and does not have any menus. To activate a configuration option, you must
type the desired command at the prompt and press Enter. You can also configure
your Avaya P330 using the P330 Manager with its graphical user interface. For
details, see the Avaya P330 Device Manager Appendix and the Avaya Multi-Service
Network Manager P330 Device Manager User's Guide on the Documentation and
Utilities CD.

Establishing a Serial Connection

Perform the following steps to connect a terminal to the Avaya P330 Master Switch
Console port for configuration of Stack or Router parameters:
1 Use the serial cable supplied to attach the RJ-45 console connector to the
Console port of the Avaya P330 Master Switch. Connect the DB-9 connector to
the serial (COM) port on your PC/terminal.
2 Ensure that the serial port settings on the terminal are 9600 baud, 8 bits, 1 stop
bit and no parity.
3 When you are prompted for a Login Name, enter the default login. The default
login is root.
4 When you are promoted for a password, enter the user level password root.
5 Now you can begin the configuration of Module or Stack parameters.
Avaya P333T User's Guide
31