Establishing A Serial Connection; Establishing A Telnet Connection - Avaya P333T User Manual

Chapter 5 Cajun Campus CLI - Architecture, Access & Conventions

Establishing a Serial Connection

Perform the following steps to connect a terminal (physical or emulation) to the
Avaya P330 Master Switch Console port for configuration of Stack or Router
parameters:
1 Use the serial cable supplied to attach the RJ-45 console connector to any
Console port of the Avaya P330 Master Switch. Connect the DB-9 connector to
the serial (COM) port on your PC/terminal.
2 Ensure that the serial port settings on the terminal are 9600 baud, 8 bits, 1 stop
bit and no parity.
3 When you see the "Welcome to Avaya P330" menu and are prompted for a
Login Name, enter the default login. The default login is root.
4 When you are promoted for a password, enter the user level password root.
5 Now you can establish a connection to the Router or the Master switch
(indicated when the SYS front panel LED is ON) using the Session commands
(see for details) and begin configuration of Stack or Router parameters.

Establishing a Telnet Connection

Perform the following steps to establish a Telnet connection to the Avaya P330 for
configuration of Stack or Router parameters. You can Telnet either the Stack Master
IP address or directly to one of the Router IP address:
1 Connect your station to the network.
2 Verify that you can communicate with the Avaya P330 using Ping to the IP of
the Avaya P330. If there is no response using Ping, check the IP address and
default gateway of both the Avaya P330 and the station
Note: The Avaya P330 default IP address is 149.49.32.134 and the default subnet
mask is 255.255.255.0.
Note: The Cajun P330 default IP address is 149.49.32.134 and default subnet mask is
255.255.255.0.
3 From the Microsoft Windows
from the DOS prompt of your PC), then start the Telnet session by typing:
telnet <Cajun_P330_IP_address>
For example: telnet 149.49.32.134
4 For example: telnet 149.49.32.134If the IP Address in Telnet command
is the IP address of the stack, then connection is established with the Switch CLI
entity of the Master module.
If you want to connect to the Router CLI entity, use the session command.
32
®
taskbar of your PC click Start and then Run (or
Avaya P333T User's Guide