Specifying Duplex Operation For A Port - Avaya 3500 series Getting Started

Specifying duplex operation for a port

Specify duplex operation as full-duplex mode , half-duplex mode, or auto-negotiated. You can
also reset duplex operation for a port to the factory default duplex value.
Procedure
1. Log on to ACLI in Interface Configuration command mode.
2. At the command prompt, enter the following command:
Variable definitions
The following table describes the parameters for the duplex [port <portlist>]
command.
port<portlist>
full|half|auto
default
Getting Started
[default] duplex [port <portlist>] {full|half|auto}
Variable
Specifying duplex operation for a port
Value
Specifies the port number to configure the
duplex mode. Enter the port number you
want to configure, or ALL to configure all
ports simultaneously.
Important:
If you omit this parameter, the system
uses the port number you specified in the
interface command.
Sets duplex to:
• full — full-duplex mode
• half — half-duplex mode
• auto — autonegotiation
Important:
When you set the duplex mode for
autonegotiation, ensure that the other side
of the link is also set for autonegotiation.
Sets the duplex operation for a port to the
factory default duplex value.
March 2013 73