Set Ip Route Command; Set Snmp Trap Commands - Avaya P333T User Manual

Chapter 6 Cajun Campus CLI – Layer 2

Set ip route Command

Use the set ip route command to add IP addresses to the IP routing table. You
can configure from one to ten (10) default gateways for an Avaya P330 stack.
The syntax for this command is:
set ip route <destination> <gateway>
destination
gateway
Example:
This example shows how to add a default route to the IP routing table:
Cajun_P330-N# set ip route
destination = 0.0.0.0
ROUTE NET TABLE
destination
------------------------------------------------------------------------
0.0.0.0
127.1.1.0
------------------------------------------------------------------------
ROUTE HOST TABLE
destination
------------------------------------------------------------------------
127.0.0.1
10.10.10.10
------------------------------------------------------------------------

Set snmp trap Commands

Use the set snmp trap commands to add an entry into the SNMP trap receiver
table and to enable or disable the different SNMP traps for a specific receiver. First
add the rcvr_addr and then enable/disable the different traps for it.
The syntax for this command is:
set snmp trap <rcvr_addr>
set snmp trap <rcvr_addr> {enable|disable} {all|config|fault|...}
enable
disable
80
IP address of the network, or specific host to be added
IP address of the router.
0.0.0.0 192.168.1.1
gateway = 192.168.1.1
gateway flags
192.168.1.1 1
127.1.1.1 1
gateway flags
127.0.0.1 5
192.168.1.1 7
Activate SNMP traps
Deactivate SNMP traps
Refcnt Use
1 3199
8 7606
Refcnt Use
2 131
0 0
Avaya P333T User's Guide
Interface
se0
se1
Interface
lo0
se0