Installing The Serveraid Adapter Memory Module - IBM System x3550 M4 Installation And Service Manual

Installing the ServeRAID adapter memory module

Use this information to install the ServeRAID adapter memory module.
About this task
To install the ServeRAID adapter memory module, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see "Removing the cover" on page 36).
4. Remove the ServeRAID SAS/SATA controller (see "Removing a ServeRAID
5. Align the memory module with the connector on the ServeRAID adapter and
Figure 47. ServeRAID memory module installation
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 96.
64
IBM System x3550 M4 Type 7914: Installation and Service Guide
"Installation guidelines" on page 33.
SAS/SATA controller" on page 253).
push it into the connector until it is firmly seated.