Removing The Bezel - IBM System x3550 M4 Installation And Service Manual

Removing the bezel

Use this information to remove the bezel.
About this task
To remove the bezel, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect the power cords and
3. Remove the cover (see "Removing the cover" on page 36).
4. Remove the hard disk drives and filler panels from the hard disk drive bays
5. Remove the screws from the bezel.
Figure 192. T8 Torx screwdriver
Figure 193. Bezel screws removal
6. Pull the top of the bezel out slightly; then, rotate it downward until the tabs on
298
IBM System x3550 M4 Type 7914: Installation and Service Guide
"Installation guidelines" on page 33.
all external cables, if necessary.
(see "Removing hot-swap hard disk drives" on page 218 or "Removing
simple-swap hard disk drives" on page 222).
Note: Use the T8 Torx screwdriver that comes with the new bezel to remove
the bezel.
the bottom of the bezel disengages from the chassis and set it aside.