Cabling Sas/Sata Serveraid Controller - IBM System x3550 M4 Installation And Service Manual

Cabling SAS/SATA ServeRAID Controller

Use this information to cable the SAS/SATA ServeRAID controller.
The following illustrations show the internal routing and connectors for the
SAS/SATA signal cables.
Notes:
1. To connect the SAS/SATA signal cables, make sure that you first connect the
2. To disconnect the SAS/SATA signal cables, make sure that you first disconnect
Figure 95. ServeRAID-H1110 cable connection
Figure 96. ServeRAID-M1115 cable connection
198
IBM System x3550 M4 Type 7914: Installation and Service Guide
signal cable, and then the power cable and configuration cable.
the power cable, and then the signal cable and configuration cable.