IBM System x3550 M4 Installation And Service Manual page 445

806f000f-2201ffff The System [ComputerSystemElementName] encountered a POST Error. (ABR Status)
Explanation: This message is for the use case when an implementation has detected a Post Error.
May also be shown as 806f000f2201ffff or 0x806f000f2201ffff
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0184
SNMP Trap ID: 50
Automatically notify Support: No
User response: This is a UEFI detected event. The UEFI(POST) error code for this event can be found in the logged
IMM message text. Please refer to the UEFI(POST) error code in the "UEFI(POST) error code" section of the
Information Center for the appropriate user response. Firmware Error : Sys Boot Status :
806f0013-1701xxxx A diagnostic interrupt has occurred on system [ComputerSystemElementName]. (NMI State)
Explanation: This message is for the use case when an implementation has detected a Front Panel NMI / Diagnostic
Interrupt.
May also be shown as 806f00131701xxxx or 0x806f00131701xxxx
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0222
SNMP Trap ID: 50
Automatically notify Support: No
User response: If the NMI button has not been pressed, complete the following steps:
Make sure that the NMI button is not pressed.
1.
Replace the operator information panel cable.
2.
3. Replace the operator information panel.
806f0021-2201xxxx Fault in slot [PhysicalConnectorSystemElementName] on system
[ComputerSystemElementName]. (No Op ROM Space)
Explanation: This message is for the use case when an implementation has detected a Fault in a slot.
May also be shown as 806f00212201xxxx or 0x806f00212201xxxx
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0330
SNMP Trap ID: 50
Automatically notify Support: Yes
User response:
1. Check the PCI LED.
2. Reseat the affected adapters and riser card.
806f000f-2201ffff • 806f0021-2201xxxx
Appendix A. Integrated management module II (IMM2) error messages
427