Installing A Usb Embedded Hypervisor Flash Device - IBM System x3550 M4 Installation And Service Manual

Figure 61. Fan installation
6. Insert the fan into the fan slot in the fan assembly bracket and press it down
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 96.

Installing a USB embedded hypervisor flash device

Use this information to install a USB embedded hypervisor flash device.
About this task
To install a USB hypervisor flash device, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 36).
4. Install the flash device:
until it is seated correctly in the slot and the fan connector is seated correctly in
the connector on the system board.
Note: Make sure that the newly-installed fan aligns horizontally with other
correctly-seated fans for proper installation.
"Installation guidelines" on page 33.
Chapter 2. Installing optional devices
83