Table of Contents
Advertisement
Figure 48. ServeRAID-M5015 adapter cable connection
• ServeRAID-M10i adapter: Take the signal cable that is attached to the drive backplane for drive
bays 0 through 3 and connect it to the connector on the ServeRAID adapter connector that is
closest to the power-supply cage. Connect the other signal cable so that is attached to the drive
backplane for drive bays 4 and 7 and connect it to the other connector on the adapter.
Figure 49. ServeRAID-M10i adapter cable connection
If you have other devices to install or remove, do so now. Otherwise, go to
page
100.
Installing an optional ServeRAID adapter advanced feature key
Use this information to install an optional ServeRAID adapter advanced feature key.
To install an optional ServeRAID adapter advanced feature key, complete the following steps:
Step 1.
Read the safety information that begins on
41.
"Completing the installation" on
"Safety" on page iii
and
Chapter 2
"Installation guidelines" on page
.
Installing optional devices
73
Advertisement
Table of Contents
