IBM System x3550 M4 Installation And Service Manual page 436

800b050c-2581xxxx • 806f0007-0301xxxx
800b050c-2581xxxx Non-redundant:Insufficient Resources for [RedundancySetElementName] has asserted.
(Backup Memory)
Explanation: This message is for the use case when a Redundancy Set has transitioned to Non-
redundant:Insufficient Resources.
May also be shown as 800b050c2581xxxx or 0x800b050c2581xxxx
Severity: Error
Alert Category: Critical - Memory
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0810
SNMP Trap ID: 41
Automatically notify Support: No
User response:
1. Check the system-event log for DIMM failure events (uncorrectable or PFA) and correct the failures.
2. Re-enable mirroring in the Setup utility.
806f0007-0301xxxx [ProcessorElementName] has Failed with IERR. (CPU 1)
Explanation: This message is for the use case when an implementation has detected a Processor Failed - IERR
Condition.
May also be shown as 806f00070301xxxx or 0x806f00070301xxxx
Severity: Error
Alert Category: Critical - CPU
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0042
SNMP Trap ID: 40
Automatically notify Support: No
User response:
1. Make sure that the latest level of firmware and device drivers are installed for all adapters and standard devices,
such as Ethernet, SCSI, and SAS. Important: Some cluster solutions require specific code levels or coordinated
code updates. If the device is part of a cluster solution, verify that the latest level of code is supported for the
cluster solution before you update the code.
Update the firmware (UEFI and IMM) to the latest level (Updating the firmware).
2.
3. Run the DSA program.
4. Reseat the adapter.
5. Replace the adapter.
6. (Trained technician only) Replace microprocessor n.
7. (Trained technician only) Replace the system board. (n = microprocessor number)
418
IBM System x3550 M4 Type 7914: Installation and Service Guide