Installing A Usb Embedded Hypervisor Flash Device - IBM System x3550 M3 Type 4254 Problem Determination And Service Manual

5. If you are instructed to return the flash device, follow all packaging instructions,

Installing a USB embedded hypervisor flash device

To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 174).
4. Align the flash device with the connector on the SAS/SATA RAID riser-card
5. Slide the blue lockbar toward the flash device to the locked position until it is
6. Reconnect the power cord and any cables that you removed.
7. Install the cover (see "Installing the cover" on page 174).
8. Slide the server into the rack.
9. Turn on the peripheral devices and the server.
and use any packaging materials for shipping that are supplied to you.
on page 167.
assembly and push it into the connector until it is firmly seated.
seated firmly.
Chapter 5. Removing and replacing server components
209