Installing A Usb Embedded Hypervisor Flash Device - IBM System x3550 M3 Type 4254 Installation And User Manual

11. (IBM Business Partners only) Complete the additional steps in "Instructions

Installing a USB embedded hypervisor flash device

Use this information to install a USB embedded hypervisor flash device.
About this task
To install a hypervisor flash device, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page v and "Installation
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing the cover" on page 51).
4. Align the flash device with the connector on the SAS/SATA RAID riser-card
5. Slide the blue lockbar toward the flash device to the locked position until it is
Figure 56. USB embedded hypervisor flash device installation
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 106.
for IBM Business Partners" on page 35.
guidelines" on page 43.
assembly and push it into the connector until it is firmly seated.
seated firmly.
Chapter 2. Installing optional devices
85